500300 Rev. U
Operating Instructions
3-1
3.
Operating Instructions
3.1
Applying Power
1.
Before plugging in the tape drive, switch the power switch to the OFF position
as shown in Figure 3-1.
Figure 3-1 Power Switch Location
2.
Observe the label on the rear panel to verify the drive is already configured for
the available AC voltage. It the available voltage differs, refer to Chapter 8 of
this manual to change the voltage selection.
3.
Connect the power cord to the rear of the drive as shown in Figure 3-2 and
then switch on the tape drive.
Figure 3-2 Power Connection Location
