500300 Rev. U
Tape Drive Installation
1-13
5.
Separate the inner and outer slides of the remaining assembly and attach the
rails to the drive and to the rack. Figure 1-12 shows the mounting locations for
attaching the slides to the drive.
6.
Attach a rack latch to the standoffs provided inside of right side of the bezel as
shown in Figure 1-13.
7.
With the help of an assistant, carefully slide the tape drive with attached inner
rails into the outer rails. The rails should engage smoothly and evenly.
8.
Lift both safety latches up, slide the tape drive fully into the cabinet, and
tighten the screws that hold the rails to the rear of the rack.
9.
Extend the drive out about a foot, and tighten the front mounting hardware.
The drive is now securely mounted in the rack. To remove the drive, first extend it
forward until it reaches the safety stops. Then pull both safety latches up and slide
the drive forward about an inch. The drive can then be completely removed from the
outer rails.
19.00
5.25 Maximum
Maximum
CONFIGURATION
Rack Mount
Table Top
"A" DIM
17.40
19.00
"A"
22.9
2.30
1.187
1.45
Door Clearance
C of Slide
L
Note: All Dimensions in Inches
Figure 1-12 Mounting Dimensions
