Quadratec QuadraTop Adventure Top S With Flip Back..., Быстрый старт

Страница: 9 / 14

9
FIG 57 FIG 58
FIG 59
FIG 60
FIG 61
FIG 62
When removing the quarter and rear windows from the Top deck be sure to sli-
de them out completely before pulling down. Disengage the side hook and loop
before sliding the windows out. DO NOT “Peel” the windows out!
Failure to completely disengage the windows from the “C” Channel will damage
the Top and quarter window!
See Fig 63 below.
NOTICE
FIG 63
Each Time you remove the windows:
Completely pull the windows out of the “C” Chan-
nel before pulling the windows down!
Do not “Peel” the windows out. See Fig 63.
There may be times when the “P” extrusion may come out of the “C” Channel
ends due to extreme downward pressure. This is normal. If this occurs, slide
the “P” extrusion out of the C channel and re install securing the window back
into the “C” Channel.
NOTICE
Step 8: Installing the Top to the Jeep Body
Starting at the driver’s side front, attach the side
belt rail into the vehicle body by “rolling” the plastic
into the slot (FIG 64).
Once secure move to the rear driver’s side corner
and “roll” the plastic into the Jeep body corner belt
rail as shown in FIG 65. Repeat this procedure on
the pas- senger side.
NOTE: as shown in FIG 66 there is a web loop
installed on the side of the quarter window.
This is to be used for unhooking the quarter win-
dow only and is not designed to be pulled down
on for installation!
Repeat the quarter window install on the passen-ger
side of the vehicle. You may have to pull the corners
around towards the front or back of the vehicle to
center the top on the vehicle.
Go inside the Jeep and locate the long center bow
flap. Wrap this bow flap tightly around the center
bow and secure it with the hook and loop fastener
(FIGs 67 & 68). you can now reach through the rear
zipper on each side and tighten the corner straps.
Alternate tightening to keep the top centered.
Seal hook and loop around windows (Figs 69 & 70).