Quadratec QuadraTop Adventure Top S With Flip Back..., Быстрый старт

Страница: 3 / 14

Step 2: Install Bow Mount Brackets to Roll Bar
Locate the (2) bow mounting brackets and (4)
Allen head pivot bracket bolts shown in FIG 8.
Carefully unzip the roll bar padding on the vertical
side tube to expose the two factory holes in the
roll bar. With a razor knife, trim the hard foam
where the top of the bracket will sit (FIG 9).
Step 3: Assemble and Install Door Surrounds
Locate the Drivers and passengers over door
assemblies and the “drip rail” inserts shown in
FIG12.
Separate out the driver’s side over door assembly
and corresponding drip rail insert as shown in
FIG13.
Locate and line up the three round tabs on the
drip rail with the holes located in the over door
assembly as shown in FIG14. Firmly Squeeze the round tabs down into the holes permanently secu-
ring them to the over door assembly (See FIG15).
NOTE: It may take a lot of force to squeeze these
tabs into the over door assembly. You may need
to use a rubber mallet or the edge of a table to
secure them completely.
Repeat this procedure for the Passenger side
over door assembly.
3
Secure the over door bow to the Header leg with
the attached set screw (Fig 6).Slide the bow
sleeve over the knuckles as shown in Fig 7.
Repeat this procedure on the opposite side.
Locate the bow mounting brackets over the fac-
tory holes and using the Allen head pivot bracket
bolts, install brackets to the roll bar (FIG’s10 &
11). Slip the roll bar padding back over the insta-
lled brackets carefully slipping the bracket
mounts through the slits in the roll bar padding.
Repeat on passenger side.
FIG 8
FIG 9
FIG 10
FIG 11
FIG 13
FIG 12
FIG 5
Fig 7
FIG 6