Quadratec QuadraTop Adventure Top S With Flip Back..., Быстрый старт

Страница: 7 / 14

7
FIG 47
FIG 43
FIG 46
FIG 44
FIG 45
Step 6: Installing the Top Deck to the Jeep®
With the header resting on the windshield, close
the front header latches to secure the front of the
top to the wind- shield. See FIGs 48, 49 & 50.
With the fabric installed on the header and draped
over the back of the vehicle, go to the rear corner
of the Top deck and locate the rear corner straps.
Thread the straps down
Attach the spring end to the webbing as
shown in figs 46 and 47.
Using pliers, crimp the spring end so it does
not come loose.
Do not tighten this strap yet.
and under the seat belt mount as shown in FIGs
51 & 52 and thread the strap through the buckle
(Figs 53 & 54). Repeat this on the other side of
the vehicle and while pulling towards the rear of
the vehicle, slightly tighten one strap and then
the other side strap tightening up the top deck.
When
first tightening the rear straps notice the
location
of the rear bar sewn into the pocket on
the top deck. It needs to be centered on the rear
roll bar legs.
FIG 48
FIG 49
Note: FIG 47 Shows a D-ring attached to the
strap/spring. There is no D-ring on this strap.
This picture is for reference only