3
FIG 2
Passenger Front door surround
Driver Front door surround
FIG 3
Step 2: Secure Front Door Sur-
rounds to the Roll Bar
Locate the set of screw knobs and
the driver’s side front door surrounds
(Fig 2). There should be 2 sets of
four knobs. See fig 1. These knobs
go on the front and rear holes of
the brackets.
Line up the front driver’s side door
surround bracket holes with the
vertical holes in the over door
horizontal roll bar. Slip the front two
knobs through the brackets holes in
the front door surround (FIG. 3)
lining it up with the hole in the top of
the surround bracket on top of the front
horizontal roll bar. If you use a rolling
motion while you push the brackets,
it will be easier to install. Repeat on
the passenger side of the vehicle (See
note
to the right
). Loosely tighten each
of the knobs securing the front door
surround.
Step 3: Rear Over Door Surround
Assembly
Locate the driver’s side rear over
door assembly, the driver’s side
Pillar assembly, the Rubber seal
and the 4mm Allen head wrench (Fig
5).
On the driver’s side rear over door
assembly, there are two screws
installed for shipping (Fig 6). Remove
these screws and set aside. Place the
rubber seal on the driver’s side pillar
assembly (Fig 6A) Line up the Driver
side pillar assembly and the driver side
rear over door assembly as shown in
fig 7. Insert the screws and tighten
using the included 4mm Allen wrench
securing the two pieces (fig 8)
Note:
if you have difficult lining up the top of the
knobs with the upper bracket hole, you can
remove the installed top brackets covering the top
hole to get a better view of how the screw lines up.
FIG 5
Passenger
side Pillar
Assembly
Driver
side Pillar
Assembly
4mm Allen
Wrench
Driver side Rear Over-Door
Assembly
Passenger side Rear Over-Door
Assembly
FIG 6
FIG 8
FIG 7
Rubber
Seal
FIG 6A
