The Trusted Source
®
4
Installation Step Two (continued):
With the Bumper properly positioned,
place a supplied washer over the existing
bolt and secure one side of the bumper to
the frame. (Fig 5). DO NOT TIGHTEN.
Repeat the bolt and washer combination
for all top bolt locations. Loosely install
all bolts before tightening any bolt.
Starting on the driver’s side, alternate
tightening each bolt, until all are tight
making sure that the bumper is centered
on the vehicle. Using a Torque Wrench,
tighten the bolts to the following Torque
Specifications:
Torque Specifications: Top and Bottom factory,
frame mount to bumper bolts = 75 ft-Lbs
Winch Mounting plate to winch if applicable = 32 ft-Lbs
(See winch plate instruction sheet)
At this point if you plan on installing a winch plate (not included), now
is the time to reference the winch plate instruction sheets for proper
installation of the winch plate and winch. By reviewing this now, it will
save you time and hassles in the future, as the winch plate and bumper
should be installed simultaneously.
Figure 5
Non-Winch Bumper Version
shown Installed with optional aux-
illary lights (not included)
Winch Bumper Version shown
Installed with our Quadratec
Q11500i Winch (sold separately)
QR3_Front_Tubular_LTR.qxp_Layout 1 5/16/16 4:00 PM Page 4
05162016160217
