6
September 24, 2018
7080-165D
TREKKER FS
B. Tools And Supplies Needed
C. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for
installation and air clearance requirements.
Figure 6.1
Figure 6.2
D. Removal of Appliance from Shipping
Materials
1. Remove box and 2x4 structural boards being careful
not to damage product.
2. Using 3/8 socket or wrench remove both front bolts
from pallet mount brackets. Front pallet mount brackets
will slide outwards away from appliance
(Figure 6.1)
.
3. Using 3/8 socket or wrench remove bolts from side
pallet mount brackets. Side pallet mount brackets will
slide downwards from appliance
(Figure 6.2)
.
4.
Carefully pull appliance off of pallet and put in desired
location following Hearth Pad and Clearance to
Combustibles on pages 8 & 9.
Tools and building supplies normally required for
installation, unless installing into an existing masonry
fireplace:
• Reciprocating Saw
•
Channel Locks
• Hammer
•
Phillips Screwdriver
• Tape Measure
•
Plumb Line
•
1/4” Self-Tapping Screws
•
Framing Material
•
Hi-temp Caulking Material
• Gloves
• Safety Glasses
•
Framing Square
•
Electric Drill & Bits (1/4”)
•
Level
May also need:
Vent Support Straps
Venting Paint
Risk of Fire!
• Damaged parts could impair safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
•
Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
