23
September 24, 2018
7080-165D
TREKKER FS
F. Installation of User Interface
Figure 23.1
Plug the Bluetooth key into the appliance
(Figure 23.1)
Bluetooth Key
G. Power to Appliance and User Interface
1.
Prior to installing the power cord, turn the user interface
to OFF.
2. Make sure the was receptacle has 120vac output.
Install battery
(Figure 23.4)
Figure 23.2
Figure 23.3
Figure 23.4
Level
H. Location & Mounting User Interface
-
Make sure you have a reliable bluetooth connection
-
Maximum distance of 30 foot radius from appliance
-
On an interior wall
-
5 feet from the floor
-
Not behind doors, bookcases or other objects
-
Away from drafts and direct heat from the
appliance
Mount base plate using screws and anchors provided using
the level as a guide.
If necessary drill 3/16 holes for drywall or drill 7/32 for
plaster.
NOTE:
Using a circuit protector can protect the appliance
circuits from power surges.
3. The appliance receptacle is located on its lower, back
right hand corner. Install the cord to the appliance
reception and to the wall
(Figure 23.3)
.
• This will cause the combustion blower to turn on
for approximately 45 seconds and run a systems
check.
Shock hazard.
•
Do NOT remove grounding prong from
plug.
•
Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front of
appliance.
CAUTION
NOTE:
See user interface manual on how to operate the
user interface.
