R
September 1, 2008
7019-205C
Page 23
Santa Fe Pellet Insert
1
.
A 12 volt AC thermostat is required to operate this pellet
appliance. You may use the included wall mount thermo-
stat or purchase an optional programmable thermostat
or remote control.
The included thermostat is equipped with an adjustable
heat anticipator. The current rating is .05 amps. The
anticipator needs to be adjusted to the lowest setting
available.
2.
When mounting a thermostat on a wall, be sure to follow
your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu-
rate readings. The thermostat should be mounted on
an inside wall and not in direct line with the appliance
convection air. Remove any packaging from inside
the thermostat before using.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired tem-
perature in your home.
3.
There is a 4 screw terminal block located on the junction
box to the right of the power cord inlet. The center 2
screws are for the thermostat wires. The outer 2 are the
mounting screws for the terminal block.
Figure 23.1.
J. Thermostat Installation
Figure 23.1
Shock hazard.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded 3 prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appli-
ance.
CAUTION
unction Box
Cut Away
LEFT SIDE
unction Box, Front
Power
Cord
Recepticle
Terminal Block
Center 2 Screws
for Thermostat
Wires or Remote
110 Outlet for
Remote
Control Only
(unfused)
Fuse
Red Call
Light
The 110 outlet on the junction box is for a remote
control ONLY. Do not use outlet for any other
purpose. It can damage the appliance and it will
void your warranty.
CAUTION
