Page 18
7019-205C
September 1, 2008
R
Santa Fe Pellet Insert
C. Optional Grille Removal and Installation
Figure 18.1
Grille Bracket Cover
(shipped flat from factory)
Finger bend into position
after grilles are installed
on appliance
Insert heat exchanger rods
through holes on second grille.
Heat Exchanger
Rods
Install bottom 3 grilles before
installing single top grille
Install in flat position
Bend after grilles installed
1. Open the door. Remove the top 2 screws on each side
of upper grille and remove the single grille. Remove
the bottom 2 screws on each side and remove the 3
grilles attached together.
2. Removing the ash drawer before taking off the lower
grille will make the lower grille easier to remove. Using
a Phillips head screwdriver, remove the 2 screws on
each side and pull forward with a downward motion to
avoid catching the grille on the firepot pull rod.
NOTE: The plated grilles, Nickel, Black Nickel and
Gold, have 4 black grille bracket covers to elimi-
nate the brightness of the bracket plating. The
bracket covers are shipped flat, installed on the
grilles, and after the grilles are installed on the
appliance they are then finger-bent into position.
4. Attach the 4 grille bracket covers to the lower 4 grilles
and the top 3 grilles. Slip the metal strips through the
grille openings and secure to grille with screws pro-
vided. Do not finger bend the cover brackets at this
time.
5. Secure the lower grille to the appliance with 2 screws
on each side. Finger bend the bracket covers around
the plated brackets.
6. The upper grille has 2 separate parts. Install the 3
grilles attached together first. Angle the grilles down-
ward and insert the heat exchanger cleaning rods
through the holes in the second grille and then twist
forward until horizontally level. Attach the grille with
only the bottom 2 screws on each side of grille. Do not
finger bend the cover brackets at this time.
7. Position the single top grille over the 3 already in place.
Attach with one screw on each side through the top
grille and the other 3 grilles to secure to appliance.
8. Finger bend the bracket covers on the upper grille into
place.
9. Re-install the ash drawer.
Included in Kit:
(4) lower grilles; (3) upper grilles,
(1) upper grille; (4) grille bracket covers; fasteners
Tools Required:
#2 Phillips head screwdriver
