Grand Bay 40 Direct Vent Freestanding
Page 11
January 2000
1. Install rear log on log shelf ensuring that both
log shelf and log are pressed firmly against
back wall.
2. Install front log by positioning over
centering pins and lowering. (Take care
not to force and cause damage to molded
holes in bottom of log.)
INSTALLING THE LOG SET
CORRECT LOG PLACEMENT IS IMPORTANT TO PREVENT SOOTING! The vacuum-
formed ceramic logs are extremely fragile. PLEASE HANDLE CAREFULLY. Small chips on the logs
can be covered up using the touch-up paint supplied with the stove.This appliance has been supplied with
external shutter adjustments. Loosen the 3 shutter locking screws at left side of burners. (If this appli-
ance is a Direct Vent this is not necessary)
3. Place right twig on front and rear log using ce-
ramic pins and placement holes in bottom of twig
for alignment. (If ceramic pins are too close, tilt
front log forward, do not make new holes in
twigs.) Repeat step for left twig.
4. Place ember nuggets across front of burner.
5. Light appliance and let logs cure for 30 minutes. Adjust shutters to give good flame characteristics.
NOTE: If flame tips have dark yellow or black tips, shutters need to be opened.
6. After correct flame adjustment has been achieved, cool appliance, remove twigs and front log and
tighten shutter adjustment screws.
IMPORTANT: If shutter adjustment screws are not tightened, expansion and contraction of burner
can allow shutter to close and cause sooting.
SHUTTER
CENTERING PINS
CERAMIC
INST
ALLA
TION:
LOGS
