Page 9
5100-I ACT WOOD INSERT
R
438-0380D
September 1, 2008
Quadra-Fire stoves are equipped with ceramic super heat-
resistant glass, which can only be broken by impact or
misuse. Do not slam stove door or impact the glass. When
closing door, make sure that logs do not protrude against the
glass. Inspect glass regularly. If you find a crack or break,
immediately put the fire out and return the door to your dealer
for replacement of glass before further use.
5.
Cleaning Plated Surfaces
• Frequency:
As necessary
• By:
Homeowner
• Task:
Clean all the fingerprints and oils from plated
surfaces
BEFORE
firing the appliance for the first time.
If not cleaned properly before lighting your first fire, the
oils can cause permanent markings on the plating. Use
warm soapy water and a soft rag, glass cleaner and a
paper towel, or vinegar and a paper towel to remove the
oils. After the plating is cured, the oils will not affect the
finish and little maintenance is required. Wipe clean as
needed.
A portion of the combustion air entering the firebox is
deflected down over the inside of the door glass. This
air flow “washes” the glass, helping to keep smoke from
adhering to its surface. When operated at a low burn
rate, less air will be flowing over the glass and the smoky,
relatively cool condition of a low fire will cause the glass
to become coated. Operating the appliance with the
Primary Air Control all the way open for 15-0 minutes
should remove the built up coating.
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
slamming glass.
• Do NOT clean glass when hot.
CAUTION
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white film.
• Use commercial oven cleaner on heavier deposits.
• Remove all residue of oven cleaner or will permanently
stain glass on next firing.
• Refer to maintenance instructions.
Glass
Assembly
CAUTION
• Do not use polishes with abrasives, it will scratch plated
surface.
B. Glass Replacement - Door Assembly
• Frequency:
As needed
• By:
Homeowner / Qualified service technician
• Task:
See the following instructions.
1
. Ensure that the fire is out and the appliance is cool
to the touch.
. Protect a table or counter top with padding or
towels.
. Remove the door with the broken glass by lifting the
door up and off of the hinges.
4.
Lay door face down on a table or counter making sure
the handle hangs over the edge so the door lays flat,
on a soft surface.
5. Remove the screws from each glass retainer and
remove the glass. (If screws are difficult to remove,
soak with penetrating oil first).
6. Center the new glass with edges evenly overlapping
the opening in the door, (i.e. same space top and
bottom, left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately,
a few turns at a time, until the glass is secure. DO
NOT OVERTIGHTEN.
9. Replace the door on the appliance.
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
& door assembly removed.
WARNING
Glass
Assembly
• Do NOT operate with glass cracked, broken or
scratched.
Fire or Injury Risk
• Use only glass specified in manual.
• DO NOT REPLACE with any other material.
WARNING
