Page 1
5100-I ACT WOOD INSERT
R
438-0380E
April 21, 2010
Figure 21.1
Figure 21.2
Figure 21.3
Two leveling bolts, 3/8” x 4” are shipped inside the com-
ponent pack found inside the firebox.
NOTE:
Not all installations will require the use of the level
-
ing bolts.
1. Remove the bolts from the component pack and insert
into weld nuts welded to each side of the insert bottom
Figure 21.1.
. After securing the liner to the flue collar (or offset adapter)
and the insert is in its final position, extend bolts down
-
ward to level insert.
B. Leveling Bolts
7
Appliance Set-up
Standard Size: 0-1/” h x 7” w
Large Size: -1/” h x 51-1/” w
Do not tighten sides until
top is locked into place
Panel brackets
a. Loosely install the 2 side panels, do not tighten, using
the cage nuts already attached to the appliance.
(Note: The sides are not interchangeable).
Figure
21.3.
b. Put top panel in place pushing straight back and then
to the right to lock onto top of side panels. Attach
the top panel to the sides using the panel brackets
included in the fasteners package.
Figure 21.2.
c. Tighten side panels to the appliance using a long-
handle screw driver.
Back view of top and
side panel assembled
Panel
bracket
Cage nut
1. Attaching Panels to the Insert
C. Panel & Trim Set Installation
Kit Includes:
(
) Side panels, left & right
(1) Panel top & fastener package
() Side trim, left & right
(1) Trim top & fastener package.
Tools Needed
:
Screwdrivers:
Powered Phillips head
Long-handled Phillips head
A. Installation Outline
1. Record serial number on back cover of manual.
. Remove the leveling bolts from the component pack and
start the bolts in the weld nuts.
Figure 21.1.
. Position insert on hearth with rear of insert extending into
fireplace opening. Slide insert on its base into the open
-
ing leaving approximately 4 inches (102mm) protruding
out the front.
4. Assemble the panels and temporarily attach to insert.
Push insert into opening leaving 1 inch (5mm) protrud
-
ing out the front. Confirm the panel size is correct for the
opening and that the face can be sealed off from room
air when installation is complete.
Figures 21.2 & 21.3.
5. Remove the panels and secure liner to the chimney
ring.
6. Level the insert in its final position in the fireplace. If an
offset adapter is required for installation, install it first and
then secure liner to offset adapter.
7. Install the Panel & Trim set and (if applicable) the Zero
Clearance Trim Support.
,EVELING"OLT
