August 3, 2015
7033-277N
Page 5
3100 Wood Stove Series (ACC)
R
2
Getting Started
A.
Design, Installation & Location Consider
ations
Consideration must be given to:
•
Safety
•
Convenience
•
Traffi c fl ow
• Chimney and chimney connector required
It is a good idea to plan your installation on paper, using exact
measurements for clearances and fl oor protection, before
actually beginning the installation. If you are not using an
existing chimney, place the appliance where there will be a
clear passage for a factory-built listed chimney through the
ceiling and roof.
We recommend that a qualifi ed building inspector and your
insurance company representative review your plans before
and after installation
If this appliance is in an area where children may be near it
is recommended that you purchase a decorative barrier to go
in front of the appliance. Remember to always keep children
away while it is operating and do not let anyone operate
this appliance unless they are familiar with these operating
instructions.
B. Fire Safety
To provide reasonable fi re safety, the following should be given
serious consideration:
1. Install at least one smoke detector on each fl oor of your
home to ensure your safety. They should be located
away from the heating appliance and close to the sleeping
areas. Follow the smoke detector manufacturer’s
placement and installation instructions, and be sure to
maintain regularly.
2. A conveniently located Class A fire extinguisher to
contend with small fi res resulting from burning embers.
3.
A CO detector should be installed in the room with the
appliance.
4.
A practiced evacuation plan, consisting of at least two
escape routes.
5.
A plan to deal with a chimney fi re as follows:
In the event of a chimney fi re:
a
Evacuate the house immediately.
b. Notify
fi re department.
WARNING
• DO NOT CONNECT THIS UNIT TO A CHIM-
NEY FLUE SERVICING ANOTHER APPLI-
ANCE.
• DO NOT CONNECT TO ANY AIR DISTRIBU-
TION DUCT OR SYSTEM.
May allow fl ue gases to enter the house.
Asphyxiation Risk.
Fire Risk.
WARNING
• Do not operate appliance before reading and
understanding operating instructions.
• Failure to operate appliance properly may
cause a house fi re.
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult insurance carrier, local building, fi re offi cials or
authorities having jurisdiction about restrictions, installation
inspection, and permits.
CAUTION
NOTE: Service Space
In order to replace the tube channel a clearance of 19
inches (483mm) is required on the right side of stove in
order to remove the tubes with the stove in place.
If space is not available, the stove will have to be discon-
nected from the chimney to proceed with the tube replace-
ment.
See page 37.
