Quadlogic MiniCloset-5c, Руководство по установке, Страница: 70 / 117

Chapter 7 Communications
© COPYRIGHT 2009
Quadlogic Controls Corporation
66
Once the login string has been delivered, the Quadlogic meter will display a Quadlogic
Copyright message followed by the “CIP#” prompt. The “CIP#” prompt is the indication that
the login was successful and the next command can be entered.
Figure 7-6. CIP# Prompt
Throughout this section, the “_” (underscore) will denote one (1) space. Also note that all
commands are case sensitive.
B
ASIC
M
ETER
D
ATA
I. Requesting Meter Data
Quadlogic meters are comprised of two separate sections; the mdt (Meter Data Totals)/TOU
and the mdw (Mass Memory/Data Log).
The meter can be programmed for a total of 16 discrete billing parameters depending on
how the meter is configured. Each register provides for a unidirectional billing register, TOU
function, demand register, and/or interval log.
II. Meter Data Totals
Access to the main billing registers is gained by entering mdt_-T<enter>.
Where: Serno – specific meter’s serial number
M# - meter number
Q# - Billing quantity number (#1 is kWh, see Advanced Programming for a complete
list of available billing parameters)
T# - Number of periods in the active Time-of-Use Schedule
TOU – Time-of-Use period annunciator
Units – Billing Parameter
Cons – Total real-time consumption (before multiplier is applied)
Consdate – Consumption date
Peak – Peak demand of given billing parameter (before multiplier is applied)
Time of Peak – Time of peak demand