2
!
Do not wear loose fitting clothes,
long hair, gloves, ties or jewelry.
WARNING
• Quackenbush drills are designed to operate on
90psig (6.2 bar) air
pressure
. Excessive air pressure can increase the loads and
stresses on tool parts and drills, and may result in breakage. The
installation of a filter-regulator-lubricator in the air supply line is
highly recommended.
• Before removing a tool from service or changing drill bits, make sure
the air line is shut off and drained of air. This will prevent the tool
from operating if the throttle is accidently engaged.
• Cutting tools used with these Quackenbush drill motors are sharp.
Handle them carefully to avoid injury.
Before mounting any positive feed drill, check the lock screws in the
tooling fixture and drill bushing. Make sure both are in good condition
and securely tightened.
Positive feed drills can exert high torques and high thrust loads. If
failure of the lock screws or drill bushing occurs, the drill may
suddenly spin and back away from the drill fixture.
Warning Labels
The warning labels found on these tools are an essential part of this
product. Labels should not be removed. Labels should be checked
periodically for legibility. Replace warning labels when missing or
when the information can no longer be read. Replacement labels can
be ordered from the manufacturer.
For your safety and the safety of others, read and understand
the safety recommendations and operating instructions.
Always wear protective equipment:
For additional information on eye and face protection, refer to
Federal OSHA Regulations, 29 Code of Federal Regulations, Sec-
tion 1910.133., Eye and Face Protection, and American National
Standards Institute, ANSI Z87.1, Occupational and Educational Eye
and Face Protection. Z87.1 is available from the American National
Standards Institute, Inc., 11 West 42nd Street, New York, NY 10036.
Hearing protection is recommended in high noise areas, 85 dBA or
greater. The operation of other tools and equipment in the area,
reflective surfaces, process noises and resonant structures can
substantially contribute to and increase the noise level in the area.
For additional information on hearing protection, refer to Federal
OSHA Regulations, 29 Code of Federal Regulations, Section 1910.95,
Occupational Noise Exposure, and American National Standards
Institute, ANSI S12.6, Hearing Protectors.
Follow good machine shop
practices. Rotating shafts and
moving components entangle
and entrap, and may result in
serious injuries. Never wear
long hair, loose-fitting clothes,
gloves, ties, or jewelry when
working with or near a drill of
any type.
Safety Recommendations
CAUTION
!
CAUTION
!
CAUTION
!
Personal hearing protection is
recommended when operating
or working near this tool.
WARNING
!
Impact resistant eye protection
must be worn while operating
or working near this tool.
Tool Nose
Standard Threaded
Drill Bushing
Lock Screws
Tooling Fixture
• Wear impact resistant eye protection.
• Hearing protection is recommended.
• Avoid contact with rotating spindle or cutter.
• Wear respirator as necessary.
• Exposure to repetitive work motion
and/or vibration can injure your hands
WARNING
!
and arms.
203246
CAUTION
!
382788
DO NOT ENGAGE RAPID
ADVANCE AND GREEN "DRILL"
BUTTON AT SAME TIME.
To rapid advance the drill, rotate
rapid advance lever clockwise.
To stop rapid advance,
release rapid advance lever.
To begin drilling cycle, push the
green "DRILL" button. To stop the drill
before the completion of the drilling
cycle, push the red "STOP" button.
CAUTION
!
203245
Read operating
instructions before
using tool.
382788
COMPLETE LABEL
KIT - 641028
203245
203246
Содержание 230QGDAB Series
Страница 13: ......
Страница 19: ...19 ...
Страница 22: ...22 NOTES ...
Страница 23: ...23 NOTES ...