QMS 3225, Руководство по установке лоткового модуля

Страница: 7 / 24

Adding Paper to
the LLCIT
3 QMS 3825/3225 Large-Large-Capacity Input Tray Option
Adding Paper to the LLCIT
The LLCIT holds up to 2,500 sheets of paper in letter, legal, ledger,
A3, A4, and B4 sizes. Once the size is set, add paper of the same
size and orientation as the paper that was previously loaded.
» Note: Only a qualified QMS service technician should change the LLCIT paper
size. Service instructions begin on page 4. If you damage the printer or the
Large-Large-Capacity Input Tray while changing the size settings, it will
affect your warranty.
To add paper to the LLCIT
1 Remove the upper and lower input bins.
2 Push the Tray Down button to lower the interior paper tray.
The tray moves slowly.
3 When the light stops flashing, open the LLCIT door and lift
the clear plastic lid.
4 Remove and discard the top and bottom sheets from the new
paper supply.
Top and bottom sheets sometimes have traces of glue which can
cause jams.
5 Follow the paper manufacturer’s instructions as to which
side of the paper should be printed on first.
Printing on the proper side first helps prevent excessive paper
curl, which is especially important if you are using the optional
Large-Capacity Output Stacker (LCOS). The paper wrapper usu-
ally has an arrow to indicate which side to print on first. Load
paper so the arrow points up.
6 Bow the paper slightly to insert it into the bin, and slide it in
until it is aligned with the innermost edge of the bin.
» Note: Make sure to use the same size paper in the same orientation as
you were using before.
7 Close the lid, and shut the door until it snaps.
8 Wait for the paper tray to reach its uppermost position.