QMS 2425, Справочник

Страница: 151 / 244

(QG-RE0RGH
$GGLWLRQDO7HFKQLFDO,QIRUPDWLRQ
3&3ULQW6HUYHU
1 Set the end job mode from the printer’s control panel.
2 Create a job separator to append an EOD command and
send it between each print job.
2WKHU3ULQW4XHXLQJ6\VWHPV
If you use a print queuing system other than a PC print server and
you experience what appears to be an EOD command problem, you
may need to use another procedure, such as a print utility, an initial-
ization sequence, or a header page to add an EOD command. See
your print queuing system documentation, your network administra-
tor, or your QMS vendor for more information.
6HWWLQJWKH(QG-RE0RGHYLDWKH&RQWURO
3DQHO
Use the following procedure to set the end job mode from the printer’s
control panel for printers connected via the optional serial or parallel
interface to a stand-alone PC, a PC print server, or some other type of
print queuing system.
» Note: If you print both serial and parallel protocol jobs, then you must
set the end job mode for each protocol.
Wait for the printer to go idle, and then press the control panel keys in
the order shown in the following instructions to access the End Job
Mode option. The printer responds by displaying a status message in
the message window.
» Note: You may need to press the Next key one or more times to
advance through the list of selections or options.
Key Purpose Message Window
Online Turns off the Online indicator
and readies the printer for
configuration.
IDLE
Menu Accesses the configuration
menu.
CONFIGURATION
OPERATOR CONTROL