'XSOH[LQJ
3ULQWHU&RQILJXUDWLRQ
(PXODWLRQ
The K Mem Emulation, listed on the status page as Emulation, is the
number of kilobytes of RAM to be used by non-PostScript emulations
for temporary storage and for loading optional emulations.
Menu
Administration/Memory/Manual Config/K Mem
Emulation
Choices
01024-99999
Notes
If you receive an emulation error, you may need to
increase the amount of memory for this client.The
maximum value listed depends on the amount of
memory installed and if a hard disk is present.
QMS recommends that you should add at least 1MB of
physical RAM to your printer and increase this memory
client by 1 MB. If disk swapping option is turned on then
you can increase the emulation memory client using
this memory. Failure to add memory to this client may
prevent the printer from loading and using the
emulation. Check the documentation included with the
loadable emulation for information on additional
resources requirements.
If you change the K Mem Emulation value, the printer
automatically restarts after you save your changes and
exit from the configuration menu.
Содержание 2425
