Qlogic QConvergeConsole CLI 2400 Series, Руководство пользователя

Страница: 73 / 366

5–Fibre Channel Noninteractive Commands
Command Summary
SN0054667-00 C 5-5
Command Summary
This section lists and describes each command line option in alphabetic order,
followed by a command description.
-a
(View or Toggle Beacon Status)
Use the
-a
command to either view (1) or change (2) the status of a beacon.
To view the adapter port’s LED beacon state, issue the following command:
# qaucli -pr fc -a (< hba instance > | < hba wwpn >)(view | info)
When the adapter’s LED is flashing, the following message appears:
HBA Port x - LED Flashing is ON.
When the adapter’s LED is not flashing, the following message appears:
HBA Port x - LED Flashing is OFF.
To start or stop flashing the adapter’s LED beacon, issue the following command:
# qaucli -pr fc -a (< hba instance > | < hba wwpn >)
QConvergeConsole CLI toggles the LED’s state. If the LED is flashing, the
flashing stops. If the LED is not flashing, the flashing begins.
<
target id
>
Target ID
<
lun id
>
Logical unit number (0–255)
<
address
>
IP address xxx . xxx . xxx . xxx
(speed)
Target link speed 1.2, 4, or 8GHz
a
You can use the
-g
command to find adapter numbers.
b You assign the symbolic name. It is limited to 100 characters in length.
NOTE:

Adapter must not be in silent mode. See “-s (Silent Mode)” on page 5-33
to issue a response to this command.

The
-a
feature is not supported on QLA22 xx adapters or QLE8042
adapter.
Table 5-2. Command Variables (Continued)
Variable Definition Format