Kidgoo 2020
Subject to change. – 12|2019 –
17
Assembly
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. The buggy wheel is connected directly
with the wheel suspension attached to the frame and is mounted so that it can rotate through
360 °.
»
Lift the cabin at the front.
»
Place the buggy wheel into the wheel mount as far
as it will go, until it engages audibly with a clicking
noise.
»
Check whether there is sufficient air in the
buggy wheel (maximum air pressure: 1.9 bar). If
necessary, use an air pump for car valves to top up
with air.
a
b
Adjusting the buggy wheel
»
Set with the release button
a
and mode selector
switch (unlock key)
b
in front of the suspension
the desired operating mode:
–
Buggy mode: Buggy wheel rotatable through
360 °.
–
Walker mode: Buggy wheel running straight.
–
Trailer mode: unfasten and pull out the buggy
wheel.
Mounting the tow bar
You only require the tow bar in Trailer mode. It is used to hook up the Kidgoo behind a bicycle
equipped with a suitable coupler, see
„Connecting the trailer to a bicycle“ on page 27
.
The tow bar is attached to the tow bar mount using a locking bolt and can be used in two different
positions:
»
Attachment position: The tow bar is facing forwards.
»
Standby position: The tow bar is facing to the rear and is carried under the cabin floor.
In both positions, the tow bar is also secured with a locking pin.
»
Pull the locking button with one hand and hold it
in place.
»
Push the front button on the tow bar with the other
hand so that the locking bolt unlocks.
»
Keep on pushing down the button and push the
tow bar forwards until the mark in the tow bar
mount is reached.
»
Release the button so that the locking bolt secures
the tow bar in the tow bar mount.
»
Release the locking button so that it jumps back
into the closed position and additionally secures
the tow bar.
