16
– 12|2019 – Subject to change.
Kidgoo 2020
Tightening the backrest
The stable backrest is an important safety component. For a good stability the belts under the
seat and behind the back rest must always be tightened firmly.
»
Put the cabin in the upright position and open the
cover.
»
Check the tension of the 4 black belts under the
seat and tighten them firmly.
»
Make sure that the Velcro straps on the sides of
the interior which connect the side seat cushions
to the side wall are closed.
»
Open the cover of the compartment room and
check the tension of the 4 belts behind the backrest.
»
Tighten all belts in the rear compartment room.
Inserting the pennant
Danger!
The pennant must always be mounted in Trailer mode. Otherwise the very low
Kidgoo
is too easily overseen by other road users.
For safety reasons, we recommend putting the pennant into the pennant holder so
that it is easily visible before every journey, including in Buggy or Walker mode.
»
Insert the lower part of the pennant pole with the
attached centre piece into the slot on the left leaf
spring cover.
»
Guide the upper part of the pennant pole through
the loop on the left head protector and then insert
the pennant pole into the orange centre piece.
»
Unroll the pennant so that it can fly clearly visible
on the pennant pole.
Assembly
Mounting the locking button to the tow bar holder (Kidgoo2)
Screw the locking button including the washer to the tow bar holder.
