Q4 CONTROLLER II Operation and Maintenance Manual
Q4 Controller II Operation Manual
- 19 -
Dec 02, 2021
85350-101-000 Rev A
6.6 Menu “Sensor Setting”
For digital sensor 0 to sensor 3 configuration
To assign a sensor input to any of relays, buzzers, and strobe, the sensor must already have been
enabled in the sensor settings.
Only the enabled sensors will be polled and monitored by the controller. The sensor’s gas type and
measurement unit will be read out of each enabled sensor.
Settings
Description
Enable:
The Q4 Controller must be told that a sensor is attached to the control
system
6.7
Menu “Relay 1 - 4”
For on-board Relay1 to Relay4 configuration
Settings
Description
Enable:
The Controller must be told which relays are active
Work style:
Normal Relay Style or Buzzer Relay Style
Normally Energized
Normally De-Energized or Normally Energized
Latched
See relay configuration in 5.2
Voting Mode:
See relay configuration in 5.2
Averaging Mode:
See relay configuration in 5.2
On Delay (Minutes):
See relay configuration in 5.2
Off Delay (Minutes):
See relay configuration in 5.2
Fault Acturation:
See relay configuration in 5.2
