QDI SynactiX 2EP, Руководство пользователя

Страница: 26 / 65

Manual for SynactiX 2EP
Installation Instructions
Infrared Header (IrDA)
This connector supports wireless transmitting and receiving. Before using this function,
configure the settings for IR Address, IR Mode and IR IRQ from the “INTEGRATED PERIPH-
ERALS” section of the BIOS.
Fan Connector (PWRFAN, CPUFAN, CHSFAN)
The fan speed of these three fans can be detected and viewed in “PC Health” section of
the BIOS. These three fans will be automatically turned off after the system enters
suspend mode.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function is used. Then connect this header to the relevant connector on the
LAN adapter, set “Wake-Up by LAN/Ring” as Enabled in the “POWER MANAGEMENT
SETUP” section of the BIOS. Save & exit, then boot the operating system once to make
sure this function takes effect.
VCC
IRRX
GND
IRTX
NC
VCC
1
+5V standby
GND
Signal for waking up (active high)
FAN GND
SENSE
CPUFAN
FAN GND +12V SENSE
PWRFAN
FAN GND
CHSFAN
+12V
SENSE
+12V