Manual for KinetiZ 7A
Parallel Port Connector and Serial Port Connector (UART1, UART2)
The par allel port connector can be connected to a parallel device such as a printer, while
the serial port c onnector can be connected to a ser ial port device such as a serial port
mouse. You can enable/disable them and choose the IRQ or I/O address in “Integrated
Peripherals” from AWARD BIOS SETUP.
Line-in jack, Microphone-in jack, Speaker-out jack and
MIDI/Joystick connector
The Line-in jack can be connected to devices suc h as a cass ette or minidisc play er for
playback or recording. The Microphone-in jack can be connected to a microphone for voice
input. The Speaker- out jack allows y ou to connect speaker s or headphones for audio
output from the internal amplifier.
The MIDI/Joystick connector allows you to connect a game joystick or a MIDI device.
ATX Power Supply Connector & Power Switch (POWER SW)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER SW) should be connected to a momentary switch (power button).
When powering up your system, first turn on the mechanical switch of the power supply (if
one is provided), then push once the power button. When powering off the system, you
needn’t turn off the mechanical switch, just
Push once
*
the power button.
Note: * If you change “soft-off by PWR-BTTN” from default “ Instant-off” to “ Delay
4 Secs” in the “ POWER MANAGEMENT SETUP” section of the BIOS, the pow er
button should be pressed for m ore than 4 seconds before the system pow ers
dow n.
Installation Instruction
ATX Power Supply Connector
1
20
MIDI/Jo ystick
Speaker out
Line in
Microphone in
