Manual for KinetiZ 7A
chapter 2
Expansion Slots & I/O Ports description
Slot / Port
Description
PCI 1
First PCI slot.
PCI 2
Second PCI slot.
PCI 3
Third PCI slot.
PCI 4
Fourth PCI slot.
PCI 5
Fifth PC I slot.
DIMM1
First DIMM slot.
DIMM2
Second DIMM slot.
DIMM3
Third DIMM slot.
IDE 1
Primary IDE port.
IDE 2
Secondary IDE port.
AMR
AMR s lot.
AGP
AGP s lot.
FLOPPY
Floppy Dr ive Port.
Jumper Settings
Jumpers are located on the mainboard. Pin 1 for all jumpers are located on the side with a
thick white line ( Pin1
→
), refer to the mainboard’s silkscreen . Jumpers with three
pins will be shown as to represent pin1 & pin2 connected and to
represent pin2 & pin3 connected.
Suspend to RAM Switch (J13)
If you want to Disable Suspend to RAM function, set J13 with pin2&pin3 closed, meanwhile,
set “ACPI Suspend Type” to S1 in “Power Management Setup” section of the BIOS. Other-
wise, set J13 with pin1&pin2 closed for implementing this function.
Warning
: If you set J13 with pin2&pin3 closed and set “ACPI Suspend Type” to S3 in
“Power Management Setup” section of the BIOS, the blank screen w ill come out,
in this case, just clear CMOS and boot up the system once again.
