5
9919-211
Rev. 06082017
6.
Make sure the front wheels are straight and loosley reassemble the steering joint using the factory hardware.
In some cases the intermediate shaft at the firewall may have to be moved forward (pulled out) to mate up
with the steering joint. Because these vehicles have collapsible steering columns, it is common to extend the
intermediate shaft to attach the rack & pinion.
7.
Check factory rack bushings for inner steel sleeve. If the factory rack bushings did not come with a 5/8” I.D.
sleeve you will need to use the provided sleeves in the 3/4” I.D. rack bushings. If your mustang came with
factory 5/8” I.D. sleeves in the rack bushings they will work with your QA1 K-member. If replacing bushings and
sleeves, use Moog part number K8422.
8.
Tighten both steering rack mounts using the provided hardware. The (2) 1.8” dia. stainless washers should be
installed on both sides of the rack bushings, with a 5/8 washer on the backside of the K member mount.
(Parts List- figure 4 / Picture figure 5
)
Position for 79-95 with
factory spindles
Position for cars using
96-04 spindles
