2-7
14
15
(NOTE: the green indicator will light for about 4 seconds, step 4 must be done
within 4 seconds.)
4.Input fingerprint number “0001”, a long beep is heard, which indicates the
successful first input of this fingerprint number.
5.Input fingerprint number “0001” the second time, another long beep is heard,
the red indicator in the sensor flashes, which means the lock is ready for
enrolling group member's fingerprints. (NOTE: If the fingerprint number is
already used, the red indicator flashes once and the buzzer beeps once.)
6.Place a member finger on the sensor, when the red light in the sensor goes out,
move away the finger, a long beep is heard;
7.When the red light on the sensor flashes again, place the same member finger
on the sensor second time, till a long beep is heard, which indicates the
successful enrollment of this member fingerprint.
NOTE: A. In the Fingerprint number & Name list, up to 120 group member
fingerprints can be enrolled. But since Fingerprint number 3132 is for Master
fingerprint, therefore, actually 119 group member fingerprints can be enrolled
in each lock.
B. Master fingerprint and the group member fingerprint cannot be the same .
C. A fingerprint number will only allow to enroll one fingerprint.
D. Group member fingerprint can open the lock.
QSE7F4 USER MANUAL
QSE7F4 USER MANUAL
2.7.1 Unlock with Emergency PIN
2.7 Unlocking
3.Input the fingerprint number you wish to erase, here we take “0001” for
example. Input “0001” , a long beep is heard, which means the successful first
input.
4.Input “0001” again, a long beep is heard, and followed by another long beep,
green indicator goes out, which means the successful erasing of fingerprint
“0001”.
NOTE: By following above steps, if you input ID for deleting group for step 3
and 4, all fingerprints in the indicated group will be deleted. ( Refer to
Fingerprint number & name list)
B. To change/ cover Master fingerprint can erase ALL enrolled fingerprints.
1.Input correct 8 digits Emergency PIN:
NOTE: A. Every time you input a number, blue background will light up. The
pause between 2 presses should not be longer than 4 seconds;
B. If invalid PIN was entered 3 times continuously, the button “1”,”2”,”3” will
2.6.2 How to erase group member fingerprint?
2-8
1. The same operation with the steps 1 and 2 in 2.6.1
2. Press button “2”, a long beep is heard, red indicator goes out, green indicator
lights .(Figure2-8)
