Nixie Tube Clock ‘Frank 2 IN-16’
www.pvelectronics.co.uk
- 8 -
4.
ASSEMBLY OF THE PCB
4.1 Diodes
D1-D4
Start by bending the leads of the four diodes to approximately
match the spacing of the holes on the PCB. Insert the four diodes
taking care to match up the white bands on the components with
the component marking on the PCB. See Figure 2 below.
Figure 2
Solder in the diodes, then using the wire clippers trim off the leads.
4.2
Diode D5
D5 is the remaining black diode. Again noting the position of the
white band, place in position, solder in and trim the leads.
Figure 3
