Nixie Tube Clock ‘Frank 2 IN-16’
www.pvelectronics.co.uk
- 10 -
4.5 MOSFET
Q2
The board is very densely populated in this area. Depending on
your chosen case design, you may wish to bend the leads as shown
in figure 6, to make the profile lower.
4.6
R1, R2, R3, R4, R5
These resistors, indeed all the resistors on the board need to be
mounted upright to save space. The leads need to be formed as
shown in figure 7. Bent the leads of each resistor as shown and
solder in to the correct postion, making sure the component body
is as close to the board as possible.
Figure 8: R1 to R5 placed vertically
Figure 7: Resistor
leads formed for
mounting upright.
Figure 6:
Bending the leads of
MOSFET Q2 to lower the
profile of the board.