PURSUIT S 408 SPORT 2017, Руководство пользователя

Страница: 67 / 178

Plumbing Systems Section 5
5-5
8. Drain the vinegar solution by opening all
faucets (hot & cold), setting single faucets
to the warm position, and empty the water
tank. When the water tank is empty turn
the pump breaker(s) OFF.
9. Close all faucets.
10. Fill the fresh water tank with clean, fresh
water. The fill fitting for the water tank is
on the deck amidships, labeled WATER.
The tank should be filled until water runs
out of the vent located on the hull side
just below the fill.
11. Switch ON the fresh water pump break -
er(s).
12. Open each faucet. When a smooth flow
of water is observed from the hot and
cold tap, close the faucet. When all fau -
cets are closed, the pump(s) will shut off
as the system pressure increases. Any air
should now be purged from the system.
Leave the fresh water pump breaker(s)
ON.
13. Repeat if necessary.
5.2 Raw Water Washdown
The raw water washdown system pump is
supplied by hoses connected to a ball valve
and a thru-hull fitting located in the bilge.
Washdown Connections
Operation
Make sure the ball valve is open before
attempting to operate the raw water wash -
down system. The pump is activated by the
washdown switch located on the helm. When
activated, the pressure switch will automati -
cally control the pump. As pressure builds in
the washdown hose, the pump will shut off.
When the washdown hose is in use and the
pressure drops, the pump will turn on. Turn
the switch off when the washdown is not in
use. The raw water washdown is equipped
with a sea strainer on the intake side of the
pump, located in the aft bilge; check it fre -
quently and clean as necessary.
Priming the System
Open the ball valve and hose connector,
and activate the pressure pump. Run the
pump until all air is purged from the system.
Close the thru-hull ball valve before the boat
is hauled from the water to eliminate an air
lock in the system. It may be necessary to
re-prime the raw water system if the system
is not used for an extended period.
CAUTION
!
DO NOT operate high-pressure pump
dry, damage to pump will result. Turn
the raw water pump switch “OFF”
when leaving the boat unattended.
5.3 Livewell
Seawater is provided to the livewell by
a 12-volt circulating pump. This pump is
designed to carry a constant flow of water
to the livewell. The pump is activated by the
livewell switch on the helm. An overflow built
into the livewell automatically controls livewell
water level. Always turn livewell pump off at
the switch panel when not in use.