b. Plug in shore power cable and twist to lock,
c. Tighten locking ring onto inlet fitting.
4. Plug cord into dock receptacle and twist to lock.
5. Turn on dock breaker.
6. Turn A.C. selector switch to "dockside".
7. Check polarity light on boat A.C. main panel.
IMPORTANT NOTE: If light is red, STOP. Do NOT
put boat A.C. main breaker in the ON position.
Investigate cause immediately. If light is green, put the
boat A.C. main breaker in the ON position.
To disconnect shore power:
1. Turn off boat A.C. main breaker.
2. Turn A.C. selector switch to "OFF".
3. Turn off dock breaker.
4. Disconnect shore power cord from dock outlet.
5. Disconnect shore power cord from boat inlet and
replace cover.
6. Stow shore power cord.
TO REDUCE THE RISK OF ELECTROCUTION AND
OTHER INJURY FROM ELECTRICAL SHOCK, DO NOT
MAKE UNNECESSARY CO NNECTIO NS IN WET
W EATHER, W ITH W ET HANDS, OR W ITH W ET
CABLES AND CONNECTIONS. ALWAYS USE A
3-WIRE ELECTRICAL SYSTEM CONNECTED TO A
GROUND. DO NOT USE WORN OR DAMAGED
CABLES.
Rev. B 02/15/99
WARNING
EXTERIOR EQUIPMENT AND FEATURES
COCKPIT AREA
3000 Offshore Express
1 - 19
Содержание 3000 OFFSHORE EXPRESS
