PURSUIT 2670 CUDDY CONSOLE, Руководство пользователя

Страница: 40 / 137

2670 CUDDY CONSOLE
4-6
4.3 AC System
The AC system is fed by the shore power outlet. It is wired totally separate from the 12-volt DC
system and is equipped with an on board galvanic isolation system. All AC current is distributed
to the AC accessories through individual circuit breakers located in the AC panel. The main
breaker in the panel protects the system from an overload and the reverse polarity light indicates
any problems due to an improper shore power supply. All AC outlets are protected by ground
fault interrupters to protect against electrical shock. A cord set is provided to supply power from
the shore power outlet to the boat’s AC system.
TO REDUCE THE RISK OF ELECTRICAL SHOCK IN WET WEATHER, AVOID MAK-
ING CONTACT WITH THE SHORE CABLE OR MAKING A CONNECTION TO A
LIVE SHORE OUTLET. NEVER SPRAY WATER ON ELECTRICAL CABLES WHILE
WASHING DOWN DECKS.
TO REDUCE THE POSSIBILITY OF AN ELECTRICAL SHOCK, IT IS IMPORTANT
THAT THE AC GROUND SYSTEM IS FUNCTIONING PROPERLY AND THAT A
PROPER CONNECTION EXISTS BETWEEN THE SHORE POWER CORD AND THE
SHORE POWER INLET AND THE OUTLET GROUND CIRCUITS. IF THERE IS ANY
DOUBT ABOUT THE INTEGRITY OF THE GROUND CIRCUIT, A QUALIFIED MA-
RINE ELECTRICIAN SHOULD BE CONTACTED IMMEDIATELY AND THE AC
SHOULD BE DISCONNECTED UNTIL THE NECESSARY REPAIRS ARE COMPLET-
ED.
Recommended procedure for making a shore connection
Turn the AC main breaker to the “OFF” position. If the
dockside outlet includes a disconnect switch, turn it to the
“OFF” position also.
To avoid strain on the cable make sure it has more slack than
the mooring lines. Dress the cable so that it cannot be damaged
by chafing between the boat and the dock. Make sure the cable
does not come in contact with the water. Then connect the
cable in the plug inlet making sure the connection plug includes
a three-prong plug with a ground wire. Tighten the lock rings
on both the shore and the boat connector plugs.
Turn the dock side disconnect switch or circuit breaker to the “ON” position and check for proper
polarity. If reverse polarity has been achieved, the red polarity indicator in the AC panel will
light. If this should happen, make sure the main breaker on the panel is in the “OFF” position
and turn the dock power switch or breaker off. A special relay attached to the main breaker should
automatically turn the main breaker off whenever reverse polarity is achieved. Notify a qualified
electrician to check the wiring at the dock outlet. If the red polarity light does not illuminate when
power is supplied to the panel, the polarity is correct and the AC main switch can be moved to
the “ON” position.
Shore Power Inlet