4
SKALA ELECTRIC TOWEL WARMER (EXPOSED CABLE)
FITTING INSTRUCTIONS
Skala Electric Towel Warmer (Exposed Cable) • 2022-04-01
GB
2. GENERAL INFORMATION
Before assembly, please read these instructions carefully
and retain for future reference.
Before proceeding with the installation, unpack the product
and make sure that all the components are present, and
that there is no concealed shipping damage. Components
include:
•
towel warmer
•
instruction manual
•
accessories/mounting kit
This Towel Warmer is designed to work at an uncovered
temperature of approximately 45º°C and a covered tempe-
rature of 60º°C to 65º°C in an ambient room temperature
of 20 °C. The product is suitable for use in Zone 2 & 3 in
bathrooms and kitchens and due to the low wattage is very
economical to run.
The manufacturer accepts no responsibility, either contrac-
tual or for consequential loss, for any damage caused to
persons, animals of property as a result of incorrect installa-
tion, alteration, maintenance or improper use.
To ensure that the installation is carried out correctly and
that the unit will perform as designed, carefully follow the
instructions in this manual. Failure to follow the instructions
can not only cause malfunctions of the appliance but will
also invalidate the warranty and hence PG shall not respond
for any damage to persons, animals or property.
3. INSTALLATION – HANGING THE TOWEL WARMER
Ensure there is no electrical wiring, telephone cables, water
pipes, or gas pipes beneath the surface where you intend to
locate the towel warmer. Ensure also that the wall is strong
enough to hold the towel warmer and that the desired posi-
tion for the towel warmer is close enough so that the power
cable will reach the power supply.
WARNING:
In order to avoid a hazard for very young
children, this appliance must be installed so that the
lowest heated rail is at least 600 mm above the floor in
accordance with (IEC 60335-2-43/A1:2006)
Please check that you have all the wall bracket fitting com-
ponents as detailed below and in Fig 1:
Fig 1
4 x wall plugs
4 x M4.5x 40 screws
1 x M5 Allen key
Step 1
Remove the cover from the double-sided tape on each of
the 4 wall brackets (Fig 2).
Fig 2
Step 2
Holding the rail at a 30-degree angle, place the rail on the
wall so only the top edge of the top 2 brackets touch the
wall (Fig 3 ).
Fig 3
It is recommended to use a spirit level to ensure the rail is
level. Once you have the rail in the correct position push
the rail firmly against the wall so the taped brackets are
firmly stuck to the wall. Now loosen the grub screws on the
brackets and remove the rail leaving the wall plates stuck to
the wall.
