PUREWASH
4
Figure 3
Figure 2
A NEW
PUREWASH™
SYSTEM IS
FILLED WITH RESIN + FILTERS READY TO
GO
1. Connect the provided inlet hose to a tap or
water source
(figure 1)
.
2. Make sure the other side of the provided in-
let hose is connected to the inlet ball valve
of the pre-filter
(figure 1)
.
3. Inlet Ball valve on the pre-filter housing
needs to be in the open position to allow the
water to flow through
(figure 2)
.
4. As water passes through the system from
your pre-filter through to the reinforced pres-
sure tank the system will pressurise.( assum-
ing ball valve 2 is in closed position
(figure 3)
,
or water will run freely from the outlet if ball
valve is open.
5. Normal operating pressure is between
20-100 psi and the gauge reading is an indi-
cator that water is running through. If the
pressure gauge is not above 0 it means either
that the inlet ball valve is closed OR no water
is running through the system.
6.
WARNING
: the PUREWASH system is now
under pressure. Before opening ball valve 2
make sure that your own outlet hose is
plugged into the outlet of the PUREWASH
system. Your ‘Spot Free’ system is now ready
to use.
Figure 1
CONNECTING YOUR SYSTEM
