Puretec Hybrid-M1, Руководство пользователя

Страница: 6 / 12

6 Installation & Operation Manual Copyright © Puretec Pty Ltd 2019
Installation Requirements
Initial Installation Procedure
1. Before attempting installation check the unit to ensure the quartz sleeve is intact
within the Radfire UV Unit.
2. Locate a suitable position for the Hybrid-M1 system remembering to allow 50 mm
under the unit and 350 mm clearance to the side of the unit for lamp changes
(lamp exit and entry point can be determined by installer). A power outlet is
required.
3. The Hybrid-M1 unit has 2 mounting key holes at the rear of the bracket. Mark the
desired position on the wall where the fixings are required to go.
4. Drill the holes and install the anchors (fixing anchors not included).
5. Position the Hybrid-M1 system on the wall. Insert and tighten the fixings to hold the
system securely to the wall.
6. Turn the water off and purge the lines.
7. Connect inlet and outlet hoses to the Hybrid-M1 unit.
8. Unclip and remove the lamp from the bracket.
9. Slowly insert UV lamp into chamber through the hole of the aluminium nut end.
Connect the lamp connector to the pins on the lamp. Do not let go of the lamp until
the lamp is connected to the socket.
Never touch the quartz (glass) and lamp surface as marks or fingerprints may
interfere with UV transmission. If lamp is soiled, please clean lamp with an alcohol
based cleaner.
10. Put safety cap on the aluminium nut end. Connect the ground wire to the chamber.
Plug in power connector.
11. Use the provided spanner to tighten filter bowl until firm. DO NOT OVER TIGHTEN.
12. Turn the water on, let the water flow through – opening the downstream tap to flush
the unit for 1-2 minutes. Then check the system thoroughly for leaks.
Note: For initial use, wait 3-5 minutes to allow water to pass through the whole
unit. Turn on a downstream tap to let water flow through the unit for 2-3 minutes to
release air and impurities from the system.
13. Turn the power on and ensure that the lamp is operating. Make sure that the GREEN
LED is illuminated (refer Lamp Replacement Procedure on pg.14).