3
HYBRID M1 | Filtration & Ultraviolet All-in-One Undersink Unit
Introduction
Introduction
The Puretec Hybrid-M1 is specifically designed to kill harmful bacteria in untreated water
supplies. It uses a natural purification process that’s eco-friendly and chemical-free. It
includes pre-filtration to ensure that particulate matter does not shield micro-organisms
from the UV light.
This system will effectively treat water, depending on the required UV dosage and
existing water quality.
The system is designed for mains and rainwater supply but can be used in other
situations. For other types of water supply please contact your local Puretec stockist or
call our Puretec Customer Service Helpline at
1300 140 140
(Australia) or
0800 130 140
(New Zealand).
The Puretec Hybrid-M1 system cartridges and lamp need replacing regularly to maintain
optimum performance. This is a simple procedure when following instructions. For
replacements contact your nearest Puretec stockist.
Positioning Your System
Select suitable location that is close to the point of filtered water delivery (e.g. sink).
Remember to allow access room for changing filters and a suitable place where water
spillage will not cause damage. Location should not be in direct sunlight.
An isolation valve may be installed prior to the Hybrid-M1 system to isolate the unit for
changing the cartridges, lamps and sleeve.
Install the filter housing assembly by positioning it in the desired location, marking the
position of fixing holes and fixing with mounting screws. Allow room for the connecting
tubes and for removing the filter bowls (50 mm).
