HYD-2100.
CNC Plasma&Flame Cutting Control System
Edition of 28.07.2015
4
www.purelogic.ru
8 (800) 555 63 74
02
System board and main interface
INTRODUCTION OF OPERATING BOARD
[F1] - [F8]: Function key in different interface.
[S↑/PgUP]: Page-up key of code interface or Torch up in other interface.
[S↓/PgDn]: page-down key of code interface or Torch down in other interface.
[F+/HOME]: Accelerate or skip to the head of code line.
[F-/END]: Decelerate or skip to the tail of code line.
[1]-[9]: during the cutting process, change the cutting speed to ratio of the
speed limit you have set, for example press [1], change the cutting speed to
10% of the speed limit you have set, press [2], change the cutting speed to 20%
of the speed limit you have set.
Figure 1. Board and keys
Figure 2. System self scan
POWER ON PROCESS AND MAIN INTERFACE
When power just on, the system will go for the process of self scan:
In the starting process, there is 3 seconds to countdown, before the countdown
is over, if pressing [F2], it will enter the bios starting interface shown as Fig. 3
(please take the reference of the appendix 2 to run bios). If pressing any other
key, it will jump over the countdown and directly enter the welcome interface.
If pressing no key, it will countdown to 0 and then enter the welcome interface
shown as Fig. 4.
In the welcome interface, press any key to enter the main interface
automatically shown as Fig. 5.
