4
Section Three: Install Additional Support
L
M
3:
Tighten the two M3 set screws.
4:
Repeat steps 1 through 3 for the other sliding post.
1.5MM ALLEN
WRENCH
3
SLIDING
POST
M3 SET
SCREW
4
12:
Place all the wires and wire nut connections inside the
canopy.
13:
Align and secure the canopy to the mounting plate by
tightening the four screws.
14:
To make any adjustments to the fixture height, push the
cord grips to slide the fixture up and down until the desired
height is achieved. Release the cord grips to lock the
wires in place.
K
CORD GRIP
WIRES
JUNCTION
BOX
CANOPY
J
13
13
14
1:
Loosen (
Do Not Remove
) the two M3 set screws on the
sliding post with a 1.5mm Allen wrench.
2:
Adjust the position by moving the sliding post across the
channel.
M3 SET
SCREWS
SLIDING
POST
5
AIRCRAFT CABLE
TAB
5:
Insert the aircraft cable through the top of the tab on the
sliding post.
N
1
2
NOTE:
Follow these steps if the Glide fixture (96 inches or
longer) is provided with additional supports.
