Section One: Install the Canopy
SAVE THESE INSTRUCTIONS!
- This product is suitable for indoor locations.
- This instruction shows a typical instruction.
- Care and Maintenance: To clean wood panels (if applies)
dust them using a dry rag or use a very dry damp cloth
with furniture cleaner.
- Two additional aircraft cables are added for support when
the fixture lengths are 96 inches and up.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-GLD-C_04
Installation Instructions for
Glide Downlight - Center Feed
1
GLD_-_-C_-_
A
B
2:
Select the appropriate knockout on the mounting plate and
remove it using a flathead screwdriver or other appropriate
tool.
PHILLIPS
SCREW
MOUNTING
PLATE
CANOPY
1
MOUNTING PLATE
KNOCKOUT
2
SAFETY
CABLE
C
3
4
ANCHOR
3:
Align the mounting plate holes with the junction box. Mark
one point on each side of the junction box onto the ceiling.
4:
Tap the anchors onto the marked points up to the threaded
portion with a hammer. Then screw in the threaded portion
with a Phillips screw driver.
CEILING
JUNCTION BOX
1:
Remove the four Phillips screws from the canopy to remove
the mounting plate.
NOTE:
It is recommended more than one person to assist in this
installation.
