R
14:
For each standoff, insert the aircraft cable through the tab
on the sliding post.
15:
Adjust the height of the fixture by pushing the tab and
pulling the aircraft cable out of the side of the sliding post.
Release the tab to secure the cable in place.
16:
If necessary, trim excess aircraft cable using sharp cutters.
15
14
EXCESS
AIRCRAFT
CABLE
AIRCRAFT CABLE
TAB
16
#8 SCREW
THREADED
WASHER
THREADED
POST
ANCHOR
13
AIR CRAFT
CABLE
11
12
CEILING
10
ANCHOR
P
9:
Tap the anchors onto the marked locations up to the
threaded portion with a hammer.
10:
Screw in the threaded portion of the anchors with a Phillips
screw driver.
Q
11:
Feed the #8 screw through the threaded washer.
12:
Tighten the #8 screw completely into the anchor.
13:
Feed the aircraft cable through the threaded post. Tighten
the threaded post completely onto the threaded washer.
9
CEILING
PENCIL
AIRCRAFT
CABLE
6:
Lift the other end of the aircraft cable against the ceiling to
mark the location of the standoff.
7
: Push the tab on the sliding post and remove the aircraft
cable.
8:
Repeat steps 5 through 7 for the other sliding post.
O
8
6
SLIDING
POST
5