purecold 2CSMA1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 36 / 41

36
Pure Cold INSPIRATION2 Installation, Maintenance Manual 2022 | Issue Date: AUG 2022 REV 1
Always electrically isolate via disconnect switch before carrying out any work on the case.
Weekly Clean
Six Week Clean
Six Month Clean
•
Wipe down the internal panels and all areas that may contact retail products. Use a damp cloth with
a mild soap solution.
•
Wipe down the front panel with a damp cloth (which may otherwise attract dust where the air is
sucked in.)
•
Dependent on type of product being displayed, some cases will require more frequent or daily clean-
ing.
•
Carry out the weekly clean
•
Remove and wash removable condensing unit mesh
•
Clean the front of the Condenser Unit using an evaporator comb to remove dust and other
particles. Take care not to damage refrigeration pipes
•
Deep cleans should be carried out involving dismantling, cleaning and inspecting the case to ensure
correct operation of all areas. Only qualified personnel should carry out this process.
•
When cleaning cases only use non - abrasive, odorless detergent cleaner suitable for food hygiene envi-
ronments, diluted to the manufacturers recommended concentration.
•
When cleaning debris from the case base, in order to avoid blockages or damage, the following points
must be observed
•
When working inside the case take care not to damage any components such as fan blades or probes
and do not put strain on any cables.
•
Where electrical components are fitted with plug and sockets, these should be removed prior to
cleaning.
•
Do not directly apply water to fan motors or any other electrical components in the case.
•
Only use a soft cloth and mild glass cleaner for cleaning glass or mirrored components. - Be sure to
rinse and/or dry completely.
•
Only the internal drain of the case may be rinsed out with clean water providing the case is connected
directly to the mains drainage.
•
If the case is connected to only to the evaporative tray, care must be taken not to overfill the tray.
•
It is recommended that the case drainage ‘ U ’ bend is disconnected, cleaned out, and reconnected