PureAire Monitoring Systems, Inc.
34 |
P a g e
NOTE:
The O
2
system must have the relay module installed to access this menu. If
no relay module is installed the display will indicate N/A, (not available)
This menu will permit the setting of the two alarm relays and the fault relay settings
from a latching to a non latching state when they are activated.
From this main menu, pushing the joystick to the right will select the sub menu and the
digital display will scroll the following:
This is the menu at which to adjust the first level alarm relay state on the Air Check
O
2
Monitor.
To change this value, push the joystick right to display the relay state. The display will
Indicate
LATCH.
Pushing the joystick down will change the relay state from
LATCHING to NON-LATCHING. Press
ENTER
to accept the value.
After entering the relay state, the display will default back to the
Set Latching
menu.
The display will scroll the following:
From this main menu, pushing the joystick to the right will select the sub menu and the
digital display will scroll the following:
.Set Latching…
20.9%
..Set Latching Relay 1…
20.9%
LATCHING
20.9%
NONLATCH
20.9%
..Set Latching.…
20.9%
..Set Latching Relay 1…
20.9%
