Pure n Natural Systems, Inc.
www.purennatural.com
1
-
800
-
237
-
9199
CA-1000 | Page 2
P a g e
Install mounting angle as shown in Fig. 3, using No. 8 self-
drilling screws provided. Remove a ceiling tile centrally
located in area to be cleaned. Secure eyebolts, hooks etc. to
permanent ceiling or ceiling joists. Determine length of
chain necessary to support unit at maintaining angle or
slightly above level of T-Bar frame.
CAUTION: Do not allow full weight of unit to rest on T-Bar ceiling or frame.
Attach proper length of chain to each eyebolt on cabinet,
raise unit and secure chain to mounting devices in
permanent ceiling or joists. (see Fig. 4)
Connect electrical power to air cleaner, following
instructions under
“Electrical Wiring”.
Remove charcoal filter from plastic bag and install in
channel on down-stream side of cell. (Arrow on side of
cell points in this direction.) Re-install cell, pre-filters and carbon filter. Swing access cover up
and snap closed. Unit is now ready to place in operation.
FLUSH MOUNT INSTALLATION
Open unit cover and remove the pre-filter and cell. Select a
location near the center of the area to be cleaned and locate
the ceiling joists in that area. Locate 4 mounting points (each
being at a joist) and pre-drill holes into the joists and unit
housing as shown in Fig. 5.
Lift unit into ceiling and secure using four ¼” x 2
- ½
” lag bolts
as shown in Fig. 5. Connect electrical power to unit. (See Field
Wiring Diagram) Remove carbon filter from plastic bag and
install in guide rails on back of cell. Re-install cell, pre-filter and
carbon filter. Replace thumb screws to secure cell in position.
Close access cover and snap closed. Unit is ready for
operation.
