8
USER CONFIGURATION
SERVICE FUNCTIONS
To reset the unit:
•
Press the
MENU
button until the display shows “rSet”. Press
ENTER
to confirm.
To test the operating functions:
•
Press
MENU
until “teSt” is displayed and the sequece will commence.
OPERATION MODE
•
Press the
MENU
button and the display shows each option in sequence, then
press
ENTER
and the LCD will show modes for you to choose.
•
Use the
UP
/
DOWN
buttons to set the desired inversion, then press
ENTER
to
confirm.
To set the DMX channel configuration:
•
Press the
MENU
button until it shows “ChNd”, then press
ENTER
and the LCD will
show “16CH” or “21CH”.
•
Use the
UP
/
DOWN
buttons to set the desired channel mode and press
ENTER
to
confirm.
•
Choose a unit to function as the Master, then select one of the modes as an auto
running programme.
•
Finally, chain the units together using DMX cable, the required speed mode can be
the Master one’s programming. The other units are set to the same DMX Address.
Set Master/Slave Mode:
•
Press MODE until “SlNd” is displayed,
•
Press ENTER to chose “master”, “slave 1” or “Slave 2” modes, Press ENTER to
set the mode. This mode will allow you to link up to 32 units together without a
controller.
•
Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units.
•
Proper performance it may be necessary to use a terminator at the last fixture.
AUTO Speed Mode:
•
This mode allows a single unit to run one of four factory installed programme in a
range of 9 speeds.
Sound Mode:
•
Press
MODE
until “SeNs” is displayed.
Press
ENTER
to choose sensitivity of response by use of the
UP
and
DOWN
buttons. Press
ENTER
to set the desired level.
To set the PAN to inverting or non-inverting:
•
Press the
MODE
button until it shows “PaN”, then press
ENTER
and the LCD will
show “OFF” or “ON”.
•
Use the
UP
/
DOWN
buttons to set the desired mode and press
ENTER
to confirm.
To set the Tilt to inverting or non-inverting:
•
Press the
MODE
button until it shows “TiLt”, then press
ENTER
and the LCD will
show “OFF” or “ON”.
•
Use the
UP
/
DOWN
buttons to set the desired mode and press
ENTER
to confirm.
LED Mode:
•
Press
MODE
until “Led” is displayed.
Press
ENTER
and then use the
UP
/
DOWN
buttons to set “ON” or “OFF” The LED
display will turn off after a time unless a button is pressed.
