Assembly, Operation & Parts Manual G-Range CV Pg
28
Important Safety Instructions
(Continued)
8.7 Power Switch
Located on the front panel at the base of the Treadmill, the ON/OFF switch has two positions: “I” (one) for ON and “0” (zero) for OFF.
To disconnect, turn all controls to the OFF position, then remove electrical plug from outlet.
8.8 Install Coaxial & Ethernet Cables (if necessary) - Series 2 & Series 3 Only
The following connection receptacles are located at the front of the 260G - Run (Low Impact 'Elevation' Treadmill):
Coaxial Cable, and Ethernet Cable.
CAUTION:
Connectors should easily fit into the receptacles. Forcing a connection may lead to damage to the barrel connector and/or
receptacle and may void product warranty.
8.9 Power Cord Routing
WARNING:
Make sure the power cord is unplugged before attempting to route it around or through the Treadmill.
The power cord can be run to the user-front left or right sides. Excess power cord can be bundled and tied under the front of the
Treadmill. Route the power cord so that it is not walked on, pinched, or damaged by items placed upon or against it, including the
Treadmill.
Note:
To accommodate Treadmill incline, at least 61cm / 24” of power cord is required between the outlet and the front of the
Treadmill.
WARNING:
Make sure that there is a 2m / 6.5ft clearance behind the Treadmill. Contact PULSE FITNESS Global Service Team for a
longer power cord (if necessary).
DANGER
: Ensure that the power cord does not contact the Running Belt or get pinched between the Frame, Lift Arm or under the
Wheels; failure to follow this warning may result in serious injury.
