LOOM
Assembly, Operation & Parts Manual G-Range CV Pg
21
7.1 Wiring the Motor
CAUTION MAINS POWER 120V
Ensure
that the power is turned off and is
unplugged at the mains connection point,
BEFORE
removing the motor cover and
carrying out any work on the electrical
components.
Carefully connect the cables as indicated on the
drawing and check that all the wires are secure and
in the correct ports.
Make sure that the loom is secured
with a cable tie ensuring the wires have
enough slack to reach the ports
without any
tension
.
*Refer to document
135-839*
for further
instructions.
7
Connections to Power Supply
SERIAL CABLE
Sleeve Colour : Yellow
12V Power
Sleeve Colour :Red
COAX CABLE
Sleeve Colour :N/A
NETWORK CABLE
Sleeve Colour :N/A
EARTH CABLE
Sleeve Colour :N/A
SWITCH TO
TERMINAL BLOCK
Sleeve Colour :N/A
SWITCH TO
TERMINAL BLOCK
Sleeve Colour :N/A
HALL EFFECT
SENSOR
Sleeve Colour :N/A
12V PSU
Sleeve Colour : N/A
P13 TO FILTER SPADES
CABLE
Sleeve Colour : N/A
EARTH CABLE FILTER
Sleeve Colour : N/A
ACTUATOR /
POTENTIOMETER
CABLE****
Sleeve Colour :N/A
MOTOR POWER
CABLE***
Sleeve Colour :N/A
BRAKE RESISTOR
CABLE**
Sleeve Colour :N/A
FAN
COMMS
CABLE
Sleeve Colour :N/A
MAIN FILTER
CABLE
Sleeve Colour :N/A
FILTER CABLE
Sleeve Colour :N/A
Rhymebus
RM6T-2
Drive
Note : 100-276-* Interface P.C.B.
Cable supplied w/drive
Cable supplied w/motor
Cable supplied w/actuator
Ferrite
Magic Tape X2
as FST X50mm
27