Pulsar PG7750BCO, Руководство оператора

Страница: 15 / 26

OPERATION
1
5
Receptacles and Extension Cords
Only use high quality, well-insulated, grounded extension cords in good condition with generator receptacles. Follow
each device manufacturer’s power rating recommendation when selecting receptacle and extension cord.
This generator is equipped with the following receptacles:
Battery Charger for Electric Starter
Keep the generator battery fully charged and ready to use to avoid the need to use the recoil starter to start the generator
manually.
How to Stop Engine (See fig 15-18))
• All electrical loads MUST be disconnected from the generator. Never start or stop the engine with electrical devices
plugged in to the receptacles. (See fig 15)
When using gasoline
1.Turn the engine START/ON/OFF switch to the “OFF” position. (See fig 18)
2.Turn the fuel valve lever back to the OFF position.(See fig 16)
When using LPG
1.Turn the engine START/ON/OFF switch to the “OFF” position. (See fig 18)
2.Trun off LPG bottle. (See fig 17)
Fig 15 Fig 16 Fig 17 Fig 18
• Four 120v GFCI outlets (NEMA 5-20R) .
• 120 Volt AC, 30 Amp twist lock receptacle (NEMA L5-30).
• 120 / 240 Volt AC, 30 Amp twist lock receptacle (NEMA L14-30).
• 12 Volt DC 8.3 Amp Output .
120 Volt GFCI duplex receptacles (NEMA 5-20R)
• This receptacle has a 20 Amp push-to reset circuit breaker to protect against overload.
• Each socket is rated to operate 120 Volt, AC, single phase, 60Hz loads requiring up to 2400 watts (2.4 kW) at 20 Amps.
• Use extension cords having a minimum rating of 125 Volts AC, 20 Amps.
Pull cord recoils rapidly and can pull arm towards engine faster than you can let go could result
in injury.
• Pull starter cord slowly until resistance is felt, then pull rapidly.
WARNING!
Never start or stop engine with electrical devices plugged in to the receptacles. Failure to
heed this warning could damage the generator and / or connected electrical devices.
• Always start the engine and let it stabilize before connecting any electrical devices.
• Disconnect all electrical devices before stopping the engine.
WARNING!