www.pulsar.pl
DSOP24V
32
If the entered IP address is correct, the module login page will be loaded on the browser screen.
Fig. 26. Ethernet module login page.
If your browser does not display the above page, then check the Ethernet configuration. In particular,
check:
- Whether the addresses of the Network Interface Card of the computer and the router are on the same
subnet, that is in the range 192.168.1.0
– 192.168.1.255
- The addresses of the Network Interface Card of the computer and the router must be different than the
address of the power supply, that is 192.168.1.100
The appropriate configuration can be made in the settings of the Network Interface Card.
Fig. 27. NIC (Network Interface Card) settings tab.
When the page opens, select the administrator name and enter the password. The default values are:
Name: = „Admin”
Password = „admin”
It is recommended to change administrator name and password after the first login.
The Ethernet Module allows you to restore the default login values in case they are lost. For this purpose,
remove the top cover of the power supply to access the module installed inside. Then locate the communication
module (see image below) and press the "INIT" button for approx. 5s.